![]() This will prevent the GATOR MAXX G2 from properly sliding into the joints and obtaining very densely packed joints, which is critical to the product’s performance. ![]() Do not apply if the paver joints are damp or wet.The damp or wet surface will cause GATOR MAXX G2 to prematurely activate and will lead to the polymers sticking on the paver surface. Do not apply if the paver surface is damp or wet. Pavers’ sides and top surfaces must be completely dry.Drilled holes should allow any water entering the bedding layer to freely flow out. Holes should be filled with 3/8″ (9mm) stone and covered with a 1 ft x 1 ft (30 cm x 30 cm) patch of Gator Fabric GF4.4. For overlay, ICPI recommends 2″ (5 cm) diameter drainage holes spaced approximately 10 ft (3 m) apart and at the lowest elevations in the slab. Pavers and slabs must be installed according to ICPI Tech Spec #2 traditional base (before GATOR MAXX G2 installation.Always refer to the latest GATOR MAXX G2 Technical Data Sheet (TDS) at before installing GATOR MAXX G2.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |